WARNING!
Only use ESTOP in case of an emergency. Do not use to turn engine OFF.
WARNING!
Lower engine idle and allow system to cool down before engine shut down.
WARNING!
Never shut down the engine during the regen cycle.
TURNING THE REMOTE TRANSMITTER ON:
1.
Turn the master switch on the drill unit operator station to the ON position.
2.
Push the transmitter power toggle to the ON position. The status light will illuminate and the
screen will display “Control Reset Required”
3.
Cycle the e-stop. Press and then twisting it to the right to release. This will put the remote thru
a boot up cycle and internal safety check. The transmitter is now communicating with the
receiver.
Operation 27
START/ STOP
KEY SWITCH
ENGINE DISPLAY-
SYSTEM VITALS
Summary of Contents for TRIBOR 36
