5
Assembly
1. Remove the grounds bin from the
unit and set aside.
2. Remove the single Phillips head
screw from the center rear of the rear
metal casting cover and slide the rear
casting rearward 1cm to remove it.
(see photo #1).
3. You must remove the rubber feet
from the bottom of the grinder. Use
a pair of side cutters or a butter knife
to pry the feet out. (See photo #2).
4. Coil the cord into the hole in the
bottom of the grinder, about 1/3 will fit.
(see photo #3).
5. Remove the grounds bin from the
grinder and slide the grinder carefully
into the
ESATTO
TM
from the rear going
forward until the grinder fits tightly
against the front casting.
(See photos #4 & #5).
Photo #2
Photo #3
Photo #1
Photo #4
Photo #5
