BaoLai Medical BCL-A, Instruction Manual, Page: 6 / 16

6 . Install and uninstall way
6
.
1 Install and uninstall main unit: Connect the power
supply line of LED curing light with the power (~24V) of
dental unit. Tight the nylon thread to the fixation of the
dental unit, then it will be available for operation.
Notice: When installing main unit, be sure that the
power is cut off. The two power wires should be a little
longer than the nylon thread to keep the power wires safe.
.
Install and uninstall lamp cap: Insert the lamp cap 6 2
into the hole slotting at the front end of main unit. LED
curing light can be used after installing it well. Pull out of
lamp cap to autoclave and replace it.
Notice: After installing lamp cap well, there is no gap
between lamp cap and main unit. When the metal
clamping ring
there is voice feedback. flicks,
7.Cleaning and sterilization
7.1 Cleaning
7
.
1
.
1Pull out of the lamp cap from BCL-A curing light,
wipe it with medical alcohol or with special dental
disinfection towel.
7
.
2 Sterilization
7
.
2
.
1 Pull out of the lamp cap and pack it in sterilization
pouch or sterilization box to sterilize it(135
℃
0.22MPa).
7
.
2
.
2 Sterilize with autoclave.
7
.
2
.
3 Sterilization condition.
Sterilization under one of the following conditions:
a
）
121
℃/
1bar
（
0
.
1MPa
）；
b
）
135
℃/
2
.
2bar
（
0
.
22MPa
）.
Sterilization precaution
Ensure that there is no residual liquid or resin at the
front end of lamp cap before sterilization.
Ensure the lamp cap has been uninstalled when
sterilizing.
Don't mix with other equipments when sterilizing.
The lamp cap needs natural cooling and then can be
installed and used again after sterilizing.
4