20
e.
After searching the CTCSS code, the radio will beep and stop scanning.
f.
After setting, press
[MENU]
key for confirmation and store, or press
[PTT]
or
[EXIT]
key to return to standby mode.
NOTE 1: The DCS scanning has the same procedure of CTCSS code, but you have to select MENU+10 to enter scanning.
NOTE 2: If CTCSS has not searched the code, you can search using the DCS mode.
6.4 Cursor
▼▲
Conversion (A/B)
Directly press
[EXIT]
key to move the cursor up and down. Then, you can modify or confirm the parameters indicated by the
cursor.
Important1: UV-9G has a dual-frequency display function. In frequency mode, you will see on the display two different
receiving and transmitting frequencies; while in channel mode the two different channels will be displayed.
Important2: In frequency or channel mode, press the
[EXIT]
key to shift between the main channel A and the sub-channel B
▲
on the display indicates on which channel (main channel A or sub channel B) you are operating.
▼
is displayed next to the channel.
6.5 Keypad lock
This function locks the keypad to prevent accidental pressure of the controls.
To unlock the keypad, press
[#
]
for more than 2 seconds.
6.6 FM Radio (FM)
The frequency range to listen to the radio is 65-108MHz. When listening to broadcast FM, press
[EXIT]
key switches between
65-75 MHz and 76-108 MHz band.
a. In frequency or channel mode, Press
[SK1]
to turn on the radio.
b. Select the desired radio frequency with the
▲
or
▼
keys or input the frequency. Or
•
Press [
* SCAN
] to automatically search a radio station.
c. Press [
SK1
] to exit FM radio.
Note: while you are listening to the radio, the frequency or channel of A / B receiving signal will automatically switch to
the frequency or channel mode for normal transmitting and receiving.
When the signal disappears the radio will automatically switch again to FM radio mode.
