18
5.4 Channel selection
There are two modes of operation: Frequency (VFO) mode, and Channel or Memory (MR) mode.
For everyday use, Channel (MR) mode is going to be a whole lot more practical than Frequency (VFO) mode. However,
Frequency (VFO) mode is very handy for experimentation out in the field. Frequency (VFO) mode is also used for
programming channels into memory.
In Channel (MR) mode you can navigate up and down the channel by using the
▲
and
▼
keys.
Ultimately which mode you end up using will depend entirely on your use case.
5.5 Frequency (VFO) mode
In Frequency (VFO) mode you can navigate up and down the band by using the
▲
and
▼
keys. Each press will increment or
decrement your frequency according to the frequency step you've set your transceiver to.
You can also input frequencies directly on your numeric keypad with kilohertz accuracy.
The following example assumes the use of a 12.5 kHz frequency step.
Example. Entering the frequency 432.6125 MHz on display
A
a.
The off state, hold press
[MENU]
key to open the radio, switching to the frequency (VFO) mode.
b.
Press
[EXIT]
until the
icon appears next to the upper display. .
c.
Enter
[4][3][2][6][1][2][5]
on the numeric keypad.
NOTE:
Frequency mode can be used for scanning channel storage and frequency scanning. It is forbidden to transmit in frequency
mode.
WARNING!
Just because you can program in a channel does not mean you're automatically authorized to use that frequency. However, it
is legal in most jurisdictions to listen. Contact your local regulatory body for further information on what laws, rules and
regulations apply to your area.
5.6 Channel (MR) mode
The use of Channel (MR) mode is dependent on actually having programmed in some channels to use.
Once you have channels programmed and ready, you can use the
▲
and
▼
keys to navigate between channels.
NOTE:
Channels 1-30 are GMRS communication channels, which are allowed to be transmitted. However, these frequencies are
