22
b. Press
key
and the scan of CTCSS tones will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.2.5
Scan DCS
This function allows scanning the frequencies with DCS code enabled.
a. In standby mode, press
[1][5]
; the display will show “
Scan DCS
”.
b. Press
key and the scan of DCS codes will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.3
Manual Programming (Channels Memory)
Memory channels are an easy way to store commonly used frequencies so that they can easily be retrieved at a later date.
The radios feature 999 memory channels that each can hold: Receive and transmit frequencies, transmit power, group
signaling information, bandwidth, ANI/ PTT-ID settings and a six-character alphanumeric identifier or channel name
1
.
Frequency Mode vs. Channel Mode
In standby mode, press and hold the
key to switch between frequency (VFO) mode and channel (MR) mode.
These two modes have different functions and are often confused.
Frequency Mode (VFO):
Used for a temporary frequency assignment, such as a test frequency or quick field programming if
permitted.
Channel Mode (MR):
Used for selecting preprogrammed channels.
Ex 1. Programming a Channel Repeater Offset with CTCSS Tone
EXAMPLE New memory in Channel 10:
RX =
432.55000
MHz
TX =
437.55000
MHz (This is a (+ 5) Offset)
TX CTCSS tone 123.0
a.
Press the
key to switch between menus.
Summary of Contents for UV-17R Series
Page 1: ...UV 17R SERIES...
Page 34: ......
