5.1.- INSTALLING THE ANTENNA:
Install the antenna as shown in the figure below and turn it clockwise until it stops.
Note:
- When installini the antenna, don’t rotate it by its top,
holdini it by its base and turn.
- If you use an external antenna, make sure the ‘SWR’ is
about 1.5:1 or less, to avoid damaie to the transceiver's
final transistors.
- Do not hold the antenna with your hand or wrap the outside
of it to avoid bad operation of the transceiver.
- Never transmit without an antenna.
5.2.-
INSTALLING THE BELT CLIP:
If necessary, install the belt clip at the rear of the battery compartment cover as
shown in the figure below.
Note:
- Do not use any kind of ilue to fix the screw on the belt clip.
The solvents Glue may damaie the batery casini.
5.3.
- MICRO-HEADSET INSTALLATION OF EXTERNAL:
Plug the external micro-headset connector into the jack of ‘SP. & MIC’
of the transceiver as shown in the figure below.
