1. Wet the curving water slide before connecting the garden hose to
the hose adapter.
2. Locate the end of the Water Spraying Hose Assembly that should
be attached to the inflated waterslide.
3. Attach the screw cap on the hose assembly to your garden hose.
4. Turn on the water slowly. It may take a few moments until water
begins to spray.
5. Adjust the water pressure so that the water spray on the sliding
surface of the curving slide, keeping the slide wet.
Water pressure can vary dramatically between cities. Please read the
following to answer some common questions.
Areas of LOW WATER PRESSURE:
•
For maximum performance, it is recommended to use a 5/8 in
(1.6cm) diameter garden hose.
•
If water does not arch on the slide or shoot properly.
This is usually
due to low water pressure, make sure the water is on all the way. As long
as the slides are getting wet, it will be fun to use.
•
Long hoses reduce water pressure:
The longer the hose, the farther
the water travels from the faucet thus reducing water pressure. In areas of
low water pressure, this could affect performance of the water slide. Try
using a shorter hose if you have one.
Areas of HIGH WATER PRESSURE :
•
If water shoots over the slide.
It is important that the water lands on the
slide to keep it wet and slick.
IMPORTANT WATER PRESSURE AND OPERATING
INFORMATION
4
78112 Banzai_IM (20111910)
Aqua Blast Lagoon™ Setup Diagram
Connecting the Water Hose
Water Spraying Hose Assembly
Blower Ground Stakes
Water Spraying Hose Assembly
Water slide Ground Stakes
Blower Motor
Water Bags
BY MOUTH:
Remove the
air valve plug and squeeze
the base of the valve
causing the inner flap to
open for inflation. Do not
over inflate the item.
Once the item is
completely inflated, then
insert the air valve plug to
seal it shut.
BY PUMP:
Remove the air valve plug and
insert air pump nozzle into the valve. The
air pump nozzle should be inserted deep
enough to open the inner valve flap. Be
careful not to over inflate the item. Once
the product is completely inflated, quickly
remove the air pump nozzle and re-insert
the air valve plug to seal it shut.
OR
OR
OR
NOTE:
Fill inflatable with air until the
inflatable is firm and solid. If there is any
straining at the seams, the item is over
inflated. If any seam begins to strain,
immediately stop inflation and release air to
reduce the pressure until all signs of stress
on the inflatable are gone. DO NOT use the
inflatable if there is straining at the seams.
Use of an over-inflated item may result in
serious injury, paralysis or death.
WARNING:
Overfilling will cause
damage to your ball.
This product is intended to
be used as a toy and not as a
personal flotation device.
Inflate this product with AIR.
NOTE:
For easy air inflation,
use a manual air pump designed
specifically for plastic
inflatables.
