Transform your backyard into an aqua adventure with the Aqua Blast Lagoon™!
Make your way up the side-climbing wall and race down the curved water slide
before landing with a giant splash. Cool off in the lagoon-style pool and challenge
a friend to a game of hoops before scaling the climbing wall to slide all over
again. With the included continuous airflow blower, all of this fun inflates in less
than 2 minutes. Heavy-duty Dura-Tech™ construction ensures lasting strength
and durability. What are you waiting for? Unfold, inflate, and have fun!
78112 Banzai_IM (20111910)
3
Setup Instructions
Introduction
Set up
Placement:
Use on flat lawn only, not pavement or other hard surfaces. Lawn should
be free of rocks, bumps, depressions, sticks, etc. Aqua Blast Lagoon™
should be set up in a location that has a minimum distance of 10 ft
(305cm) from any free standing structures or obstructions, including:
houses, garages, fences, trees, playground equipment, and large rocks.
1. Unfold the inflatable slide in a desired position on a smooth and level surface.
2. Layout the water hose assembly and match the number on each sprayer to the correct
position on the arch of the slide. Once the numbers are matched, attach the sprayers to
the arch using the Velcro patches provided. Secure the water tubing using the Velcro
hooks & loops located on top of the arch, and down the side of the inflatable slide.
(Fig A1-A3)
3. Attach the long intake tube at the back of the slide to the mouth of the blower motor using
the attached Velcro Strap. To ensure a secure fit, wrap the strap around the mouth of the
blower and attach the Velcro tightly. (Fig A4-A6)
4. Tie the short air release tube closed with the drawstring provided. (Fig A7)
5. Position the blower in a straight line perpendicular and level to the back
of the slide. The blower should be placed on a stable surface and
remain upright after the slide is inflated. The blower is a high volume fan
capable of moving a lot of air very quickly. Place the blower in an area
where it will not suck in dirt or leaves. Keep blower away from children,
water and moving vehicles. Set up slide far away from any structures or
obstructions. Once positioned, secure the blower with the orange
ground stakes provided.(Fig A8)
6. Do not set up over concrete, asphalt, packed earth, or any other hard
surfaces. A fall onto a hard surface can result in serious injury.
7. Locate the loops around the bottom of the slide and anchor them to the
ground with the large yellow ground stakes provided. (Fig A9)
8. Ground stakes must be completely inserted into the ground so that no
part of the stake is protruding above the ground surface. This will help
prevent tripping or injuries resulting from a fall.
9. Plug the blower into a properly grounded outlet and turn it on. The slide should inflate in
less than 2 minutes. Do not allow children to use the slide until it is fully inflated.
10. Connect the anchor bags to the side of the water slide, then fill bags with water until full
and close the caps.
Attn: Each Anchor bag should be filled with 40lbs (18kg) of water.
Each anchor bag must be attached while using the slide.
11. Close the water valve at the bottom of the pool. (Fig A10)
12.
Fill the pool with at least 8in (20cm) of water before playing.
Thoroughly wet all slide surfaces, platforms and climbing walls
before use to ensure optimal play performance.
13. After inflation, the blower should run continuously while children are playing.
14. Do not fill the product tub to more than the maximum fill line marked inside the pool wall.
Inside Tunnel
Fig. A2
Fig. A2
Fig. A1
Fig. A1
Fig. A3
Fig. A3
Fig. A9
Fig. A9
Fig. A7
Fig. A7
Fig. A10
Fig. A10
Fig. A6
Fig. A6
Fig. A5
Fig. A5
Fig. A4
Fig. A8
safety area
10 ft (305cm)
10 ft (305cm)
10 ft (305cm)
