DOscan10
I
2
Setup Menu
The DOscan10 tester contains 8 menu items in the setup menu, the
following table describes the functions of each option.
Menu Item
Option and Description
Salinity Coefficient
Set the salinity compensation coefficient of sample.
0 to 35 g/L (default 0 g/L)
Pressure Coefficient
Set the barometric pressure coefficient according to
the local altitude (refer to page 3).
450 to 850 mmHg (default 760 mmHg)
Calibration Points
Set the number of calibration points.
1 point (default)
2 points
Measurement Unit
Set the default measurement unit.
mg/L
Milligrams per liter (default)
ppm
Parts per million
%
Percentage saturation
Degrees Celsius (default)
Degrees Fahrenheit
Temperature Calibration
Refer to page 4.
Reading ± 10° C
Reading ± 10° F
Auto-Hold
If enabled, the tester will automatically sense and
lock the measurement endpoint.
Enable
Disable (default)
Auto-Power Off
If enabled, the tester will automatically switch off
if no key is pressed within 8 minutes.
Enable
Disable (default)
Factory Reset
If enabled, all of the calibration values and current
settings will be deleted or reset to the factory
defaults, the tester must be recalibrated.
Enable
Disable (default)
Setting the Default Option
1. In the measurement mode, press and hold the
Cal
key to enter
the setup menu.
2. If necessary, press the
Cal
key again to select an option.
3. Press the
Enter
key, the tester saves the current option and moves
to the next menu item.
4. Repeat steps above until the tester returns to the measurement
mode.
•
During the setting process, if you do not need to calibrate the
temperature, press the
Enter
key to skip the
/
or
/
option.
•
To exit the setup menu, press the
Meas
key.
•
The table below describes the relationship between the altitude
and barometric pressure, make sure to set a compatible
parameter before the calibration or measurement.
Option
Menu item
