+
-
+
-
+
-
+
-
+
-
+
-
Initial parameters setup (User Program Setup)
BC6HP will be operated with the default value of the essential user settings when it is
connected to a 12V DC input power source for the first time. The screen displays the
following information in sequence and the user can change the value of parameter on
each screen.
When you are willing to alter the parameter value in the program, press ‘ENTER/START’
button to make it blinking, then change the value using ‘INC’ or ‘DEC’ button. The value
will be stored by pressing ‘ENTER/START’ button once.
BC6HP recognises the cell count of Lithium battery
automatically at the beginning of process to avoid from
erroneous setting by user. But deeply discharged battery
can be perceived incorrectly. To prevent the error, you
can set the time term to verify the cell count by the
processor. Normally, 10 minutes are enough to perceive
the cell count correctly. For the battery of larger capacity,
you may extend the time term. But if you set the time
term too long for the battery of smaller capacity, the
charge or discharge process can be finished within the
time term with the erroneous cell count. This may cause
the fatal result. If the processor recognizes the cell count
incorrectly at the beginning of charge or discharge
process, you may extend the time. Otherwise, you had
better use with the default value.
Display
LiPo/LiIo/LiFe
CHK Time 10min
Display
NiMH Sensitivity
D.Peak Default
INC
DEC
This shows the trigger voltage for automatic charge
termination of NiMH and NiCd battery. If the trigger
voltage is set higher, there is a danger of overcharging
the battery; if it is set lower, there is a possibility of
premature termination. Please refer the technical
specification of the battery.
(Disable, Delicate, Default, 5mV~20mV/cell)
Disable
; The charger would not detect Delta-peak
voltage for termination. To terminate charging process,
the charger will check the parameters set up at other
safety parameters like max. capacity, safety timer or
safety temperature. If any one has been reached at its
limit, the charging process will be terminated. (for NiMH
only)
Delicate
; The charger will detect a very small variation
at delta-peak voltage. Some NiMH batteries which
shows small voltage-drop at peak need to be use this
option.
-
+
DEC INC
INC
DEC
-
+
DEC
INC
Display
NiCd Sensitivity
D.Peak Default
-
+
DEC
INC
- 7 -
+
-
+
-
+
-
+
-
+
-
+
-
-
+
-
+
-
-
+
-
+
-
+
-
+
-
!
!
!
INC
DEC
