WORLD-BEAM
®
QS30 Series –
Polarized Retroreflective Laser Sensors
8
P/N 112355 rev. A
Banner Engineering Corp.
•
Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Specifications
Supply Beam
650 nm visible red
Beam Size at Aperture
Approx. 3 mm
Laser Classification
Class 1
Supply Voltage
10 to 30V dc (10% max. ripple @ 10% duty cycle) @ 35 mA max current, exclusive of load
Supply Protection Circuitry
Protected against reverse polarity, over voltage, and transient voltages
Delay at Power-Up
1 second max.; outputs do not conduct during this time
Output Configuration
Bipolar:
1 current sourcing (PNP) and 1 current sinking (NPN)
Output Rating
150 mA maximum load
OFF-state leakage current:
< 10 µA at 30V dc
ON-state saturation voltage:
NPN:
< 1.0V @ 150 mA load
PNP:
< 2.0V @ 150 mA load
Output Protection
Protected against output short-circuit, continuous overload, transient over-voltages, and false pulse on
power-up
Output Response Time
500 microseconds
Repeatability
70 microseconds
Adjustments
2 push buttons and remote wire
Factory Defaults:
• Easy push-button configuration
• No Delay
• Manually adjust (+/–) thresholds (push buttons only)
• Dark Operate
• LO/DO and OFF-delay configuration options
• Push buttons enabled
• Push-button lockout (from remote wire only)
Indicators
Green LED:
Power ON
Yellow LED:
Output conducting
8-Segment Red Bargraph
SETUP mode:
LED 3 : Flashes Red when delay is selected
LED 2 (DO): Flashes Red when Dark Operate is selected
LED 1 (LO): Flashes Red when Light Operate is selected
RUN mode:
Signal strength (excess gain), relative to switchpoint
Model QS30LLP
Model QS30LLPC
LED 8: >6X
LED 8: >2X
LED 7: 5-6X
LED 7: 1.5-2X
LED 6: 4-5X
LED 6: 1-1.5X
LED 5: 3-4X
LED 5: 0.8X
LED 4: 2-3X
LED 4: 0.6X
LED 3: 1-2X
LED 3: 0.4X
LED 2: 0.5-1X
LED 2: 0.2X
LED 1: 0-0.5X
LED 1: 0X
Sensor calibration failure:
Alternating even-numbered and odd-numbered LEDs flash
Construction
ABS plastic housing; acrylic lens cover
Environmental Rating
IP67, NEMA 6
Connections
5-conductor 2 m (6.5') PVC cable, 9 m (30') PVC cable, or 5-pin integral Euro-style quick-disconnect fitting
Operating Conditions
Temperature:
-10° to +50°C (+14° to 122°F)
Max. relative Humidity:
90% @ 50°C (non-condensing)
Vibration and Mechanical
Shock
All models meet Mil. Std. 202F requirements. Method 201A (Vibration: 10 to 60Hz max. double amplitude
0.06", maximum acceleration 10G). Also meets IEC 947-5-2 requirements: 30G, 11 ms duration, half sine wave.
Certifications
