2x
1x
Unlock push buttons (flashing Green and Amber 1X followed by acceptance flash)
default
Lock push buttons (flashing Green and Amber 2X followed by acceptance flash)
4x
3x
Enable Auto compensation (flashing Green and Amber 3X followed by acceptance flash)
Disable Auto compensation (flashing Green and Amber 4X followed by acceptance flash)
default
5x
Enable 30 ms Off Delay (flashing Green and Amber 5X followed by acceptance flash)
6x
Disable 30 ms Off Delay (flashing Green and Amber 6X followed by acceptance flash)
default
1x
2x
Basic Configuration
(alternating flashing Green and Amber LEDs at 1Hz)
Advanced Configuration
(simultaneous flashing both Green and Amber LEDs at 1Hz)
Initiate Transparent, Film or Opaque Selection
40 ms < T < 800 ms
Timing between Pulse groups > 1 second
Pulse Timing (T)
(gray wire is input wire)
2x
1x
Set output to Light Operate (flashing Green and Amber 1X followed by acceptance flash)
Set output to Dark Operate (flashing Green and Amber 2X followed by acceptance flash)
default
4x
3x
Set offset to 8% offset (flashing Green and Amber 3X followed by acceptance flash)
Set offset to 16% offset (flashing Green and Amber 4X followed by acceptance flash)
default
3x
Toggle Teach Button Lock/Unlock
(flashing both Green and Amber LEDs 4X followed by acceptance flash)
4x
Reset to Factory Defaults
(flashing both Green and Amber LEDs 8X followed by acceptance flash)
8x
Remote
Input
Wire
5x
Set offset to 32% offset (flashing Green and Amber 5X followed by acceptance flash)
Select Translucent Mode
default
Select Film Mode
Select Opaque Mode
Select Sensor Mode
(flashing Amber LED at 1Hz)
5x
2x
1x
3x
Note:
Initiate Sensor Mode Selection is required before the selected Mode takes effect.
Configuration using remote input wire when
enabled through IO-Link
Figure 8. Remote Input Flowchart
WORLD-BEAM
®
QS18E Clear Object Detection with IO-Link
8
www.bannerengineering.com - Tel: 763.544.3164
