Scan Code Input (Available with 8-Conductor Models)
High Signal: 10 to 30 V dc at 30 mA typical
Low Signal: 0 to 3 V dc
Scan Code Selection: 8-pin/8-wire connection only (5-pin systems are
Scan Code 1)
•
Select Scan Code 1 by connecting pin 8 (violet wire) to 0 V dc or
leaving it open (not connected)
•
Select Scan Code 2 by connecting pin 8 (violet wire) to +24 V dc
Status Indicators
Amber Run Mode Indicator: indicates the System is ready for
operation
Bi-color (red/green) Status indicator: indicates general system and
output status
Bi-color (red/green) Alignment Status indicators: indicate condition
(clear or blocked beam) of a defined group of beams (±35 mm of
indicator)
7-Segment Diagnostic indicator (1 digit): indicates proper operation,
scan code, error code, or total number of blocked beams
Ambient Light Immunity
10,000 lux at 5° angle of incidence
Strobe Light Immunity
Totally immune to one Federal Signal Corp. "Fireball" model FB2PST
strobe
4.3 Emitter Specifications
Emitter Elements Wavelength
Infrared LEDs, 850 nm at peak emission
Fault Output Switching Capacity
Current-sourcing (PNP) solid-state output, 24 V dc at 70 mA maximum
Position ID Input (Available with 8-Conductor Models)
Input connected to +24 V dc to identify emitter's position as a stand-
alone
Status Indicators
One bi-color (Red/Green) Status Indicator: indicates operating mode,
lockout or power Off condition
7-Segment Diagnostic indicator (1 digit): indicates proper operation,
scan code, or error code
Scan Code Input (Available with 8-Conductor Models)
High Signal: 10 to 30 V dc at 30 mA typical
Low Signal: 0 to 3 V dc
Scan Code Selection: 8-pin/8-wire connection only (5-pin systems are
Scan Code 1)
•
Select Scan Code 1 by connecting pin 8 (violet wire) to 0 V dc
or leaving it open (not connected)
•
Select Scan Code 2 by connecting pin 8 (violet wire) to +24 V
dc
EZ-SCREEN
®
LS Basic Safety Light Screen
www.bannerengineering.com - Tel: 763.544.3164
17