5x
6x
4x
3x
2x
1x
Set Window Size to X1, then back to Run mode
Set Window Size to X2, then back to Run mode
Set Window Size to X3, then back to Run mode
Set Window Size to X4, then back to Run mode
Set Window Size to X5, then back to Run mode
Set Window Size to X6, then back to Run mode
1x
2x
1x
1x
8x
Enter Remote TEACH
RMT TCH with measurement value
Enter Remote Setup
REMOTE SETUP
Teaching..(D1SPt1)
TchSPt1 (D1) with measurement value, then to TchSPt2 (D1)
Teaching..(D1SPt2)
TchSPt2 (D1) with measurement value, then back to Run mode
1x
REMOTE TEACH
REMOTE SETUP
D1 Sensor Mode
D1-Mode with current value
Window Size
WndSize with value
Sensor Lock / Unlock
Locks or Unlocks Sensor
Lock Sensor
Unlock Sensor
Reset to Default Settings Resets Sensor to Factory Default Settings
0.04 seconds < T < 0.8 seconds
Timing between Pulse groups > 1 second
Pulse Timing (T)
NOTE: Follow procedure for the TEACH/SET method
(highlighted in black box) chosen in the TEACH Selection menu.
Timeout is 60 seconds.
3x
2x
Teaching.. (D2SPt1)
TchSPt1 (D2) with measurement value, then to TchSPt2 (D2)
Teaching..(D2SPt2)
TchSPt2 (D2) with measurement value, then back to Run mode
1x
3x
Teaching.. (D1D2SPt1)
TchSPt1 (D1 and D2) with measurement value, then to TchSPt2 (D1 & D2)
Teaching..(D1D2SPt2)
TchSPt2 (D1 & D2) with measurement value, then
1x
4x
Teaching.. (D1MdPt)
TchMdPt (D1) with measurement value, then back to Run mode
5x
Teaching.. (D2MdPt)
TchMdPt (D2) with measurement value, then back to Run mode
6x
Teaching.. (D1D2MdPt)
TchMdPt (D1 & D2) with measurement value, then back to Run mode
(teaches Spt in Switch Mode)
5x
6x
4x
3x
2x
1x
Set Mode to Alarm, then back to Run mode
Set Mode to Health, then back to Run mode
Set Mode to Switch , then back to Run mode
Set Mode to Switch , then back to Run mode
Set Mode to Window , then back to Run mode
Set Mode to Window , then back to Run mode
D2 Sensor Mode
D2-Mode with current value
2x
Run
Mode
2x
1x
4x
back to Run mode
(teaches SPt in Switch Mode)
(teaches SPt in Switch Mode)
5x
6x
4x
3x
2x
1x
Set Mode to Alarm, then back to Run mode
Set Mode to Health, then back to Run mode
Set Mode to Switch , then back to Run mode
Set Mode to Switch , then back to Run mode
Set Mode to Window , then back to Run mode
Set Mode to Window , then back to Run mode
Refer to the Window size table for the acceptable values.
Figure 14. Remote Input Map
L-GAGE
®
LE250/550 Dual Discrete Laser Gauging Sensors
www.bannerengineering.com - Tel: 763.544.3164
11
