Sourcing (PNP) Input
Euro-style Male Pinouts
Key
7
6
2
1
5
4
8
3
12–30 V dc
Module
C1
C2
C3
C4
C5
C6
5
6
7
1
8
2
3
4
1 = white
2 = brown
3 = green
4 = yellow
5 = gray
6 = pink
7 = blue
8 = red (event counter input, if
enabled)
C1 = Module 1
C2 = Module 2
C3 = Module 3
C4 = Module 4
C5 = Module 5
C6 = Module 6
Input wires C1 through C6 can be used to either control the light segments or can be configured as external PNP Inputs. Refer to
the DIP switch settings for configuration instructions.
Configuration Instructions
Set the Radio Module DIP Switches
Before applying power to the device, set the radio module's DIP switches.
Default configurations are noted with (*).
DIP Switches
Binding
Push Button
LED
DIP Switch 1: Radio Transmit Power
900 MHz Models
2.4 GHz Models
OFF *
1 Watt (30 dBm) operation
Disabled
ON
250 mW (24 dBm) operation
The 900 MHz radios transmit at 1 Watt (30 dBm) or 250 mW (24 dBm). While the Performance radios operate in 1 Watt mode, they
cannot communicate with the older 150 mW radios. To communicate with 150 mW radios, operate this radio in 250 mW mode. For
2.4 GHz models, this DIP switch is disabled. The transmit power for 2.4 GHz is fixed at about 65 mW EIRP (18 dBm), making the
2.4 GHz Performance models automatically compatible with older 2.4 GHz models.
DIP Switch 2: Input Wires
900 MHz Models and 2.4 GHz Models
OFF *
Input wires control lights
ON
Disables wired input control of lights and converts wires to auxiliary Inputs
If there are no lights at the end of the input wires to turn on, the inputs still function as a sourcing input.
DIP Switch 3: Event Counter
900 MHz Models and 2.4 GHz Models
OFF *
Default I/O operation
ON
Configure input 5 as a 32-bit synchronous counter at a maximum frequency of 20 Hz; disable input 6 (the
counter requires two registers)
EZ-LIGHT
®
K70 Wireless Indicator Light
P/N 192534 Rev. D
www.bannerengineering.com - Tel: + 1 888 373 6767
3
