Banner DF-G2 Series, Instruction Manual

Page: 15 / 32

Note: TEACH Selection must be programmed to dYn tcH.
1. Enter Adjust Mode.
Method Action Result
SET Button 8 Set Mode switch to ADJ Display: Red - Signal Level; Green -
Threshold
Remote Input 9 No action required; sensor is ready for
Dynamic TEACH method
2. Enter Dynamic TEACH.
Method Action Result
SET Button Click the SET rocker button Display: Flashes "dYn tch" then holds on
"1234 dYn"
Remote Input Single-pulse remote input
T
3. Present ON and OFF Conditions.
Method Action Result
SET Button Present ON and OFF conditions Display: Red - Signal Level; Green -
Threshold
Remote Input Present ON and OFF conditions
4. Exit Dynamic TEACH.
Method Action Result
SET Button Click the SET rocker button TEACH Accepted
Displays alternate "PASS" with % Minimum
Difference
10, Sensor returns to Adjust
mode
TEACH Not Accepted
Displays alternate "FAIL" with % Minimum
Difference
10, Sensor returns to Adjust
mode
Remote Input Single-pulse remote input
T
5. Return to RUN Mode.
Method Action Result
SET Button Move Mode switch to RUN Display: Red - Signal Level; Green -
Threshold
Remote Input No action required; sensor returns to RUN
mode automatically
8 SET
Button: 0.04 seconds ≤ "Click" ≤ 0.8 seconds
9 Remote Input: 0.04 seconds
≤ T ≤ 0.8 seconds
10 See
Troubleshooting on page 21 for more explanation of the % Minimum Difference displayed after the Dynamic TEACH method.
DF-G2 High Speed Expert Dual Display Fiber Amplifier with Dual Discrete Outputs and IO Link
www.bannerengineering.com - Tel: 763.544.3164 15