Note: For NPN models, the remote input pulses are
active
low as shown in the following
figures.
For PNP models, the remote
input pulses are
active
high and are inverted from the following
figures.
Remote
Input
1x
1x
3x
2x
1x
One-Point Window
4x
One-Point Light Set
6x
CAL Set
5x
One-Point Dark Set
Two-Point
Dynamic
Remote Setup
REMOTE TEACH
REMOTE SETUP
Teach Selection
1x
Completes Teach
Starts Selected Teach
0.04 seconds < T < 0.8 seconds
Timing between Pulse groups > 1 second
Pulse Timing (T)
NOTE: Follow procedure for the selected TEACH/SET method
(highlighted in black box) chosen in the TEACH Selection menu
3x
2x
1x
LO
DO
LO/DO Selection
2x
2x
1x
Button Unlock (uloc)
Button Lock (loc)
4x
Button Lock (loc) or Unlock (uloc)
8x
Factory Default Settings
Figure 7. Single Output — Remote Input Flowchart
3.4 Sync Master/Slave
Up to seven DF-G2 High Speed Expert Dual Display Fiber
Amplifier
with Dual Discrete Outputs and IO Link sensors may be used together
in a single sensing
application.
To eliminate crosstalk between the sensors,
configure
one sensor to be the master and the remaining
sensors to be the slaves. In this mode, the sensors alternate taking measurements and the response speed is 2 ms.
Note: Note: In this mode, all sensors must either be NPN or PNP output models.
1.
Configure
the
first
sensor as the Master (inPt SEL = MAST).
2. In the Master sensor set-up, enter the total number of Slave sensors you will be using (tOtL SLAV = 1 - 6).
3. For each Slave sensor used,
configure
the input as a Slave (inPt SEL = SLVE).
4. Give each Slave its own
identifying
address (SLAV Addr = 1 - 6).
5. Connect the Input wires of the Master and all of the Slaves together.
Note: Note: Giving two Slave sensors the same address will cause them to
fire
their
emitters
at the same
time
in the
firing
sequence.
3.5 Adjust Mode
Sliding the RUN/PRG/ADJ mode switch to the ADJ
position
allows the user to perform Expert TEACH/SET methods and Manual
Adjustment of the threshold(s).
Note: For the Dual Output models, when teaching CH2, the gain
setting
will be the same as the gain
setting
made during the CH1
teach. Reteaching CH1 may invalidate the previous CH2 teach.
3.5.1 TEACH Procedures
The
instruction
manual has detailed
instructions
for these TEACH modes:
• Two-Point TEACH
• Dynamic TEACH
• Window SET
• Light SET
DF-G2 High Speed Expert Dual Display Fiber
Amplifier
with Dual Discrete Outputs and IO Link
12
www.bannerengineering.com - Tel: 763.544.3164
