97282 v.3.0
19
NOTE: If using the Switch
configuration, perform steps
20-22
. If using iDash 1.8" Gauge
configuration, skip to step
23
.
20.
Plug the 4-pin connector from
the OBDII cable, the 6-pin connector
from the starter cable, and the 2-pin
connector from the switch cable into
the Y-harness
Figure 20
.
21.
Install the power level plate to
the switch. Make sure to align the slot
of the switch with the red line on the
plate towards Sport
Figure 21
.
22.
OPTIONAL: Mount switch in
dashboard by drilling two holes using
the supplied template (see page 20).
Be careful to not damage factory wiring
behind the dashboard. To keep the
switch from rotating, it is necessary
to install the locking tab washer
behind the dash, with the locking tab
facing the backside of the dash face.
Alternatively, Zip tie the switch in any
easy to access location for power level
adjustment.
NOTE: Only perform steps
23-25
if
using iDash gauge configuration. If
using the switch configuration skip
to step
26
.
Figure 20
Figure 21