2.Configuration file setting
When the screwdriver is power off, connect it to PC with
USB data cable, short press the key to activate the flash
disk; open config.txt file in the disk, and the contents are:
StartAngle=2 #(2~10)
Gear=4 #(0~4)
MotoTimeCont=0 #ReadOnly
Ver=1.1 #ReadOnly
StartAngle
The angle that starts ES120. E.g. set as
“2”, ES120 will start working at a rotation
angle of 2 degree.
Gear
Torque shifts, “0-4“ corresponds with “A-4”
MotoTimeCont
Motor service time, read only
Ver
Version, read only
VII. Firmware Upgrade
1
、
Visit www.miniware.com.cn and download the latest
ES120 firmware to your PC
2
、
When the screwdriver is power off, connect it to PC
with USB data cable, and hold the key until “DFU3.44”
displays on screen to enter DFU mode, and a virtual disk
will appear on PC.
6
Parameters
Paraphrase
Range
2~10
0~4
Note: Settings will be applied to ES120 by saving.
