6
Connect a BeoCord V 8000 video tape recorder
When you connect a BeoCord
V 8000 video tape recorder, the
television detects the connection
automatically.
For further information, refer to the
chapter
Register additional video
equipment
or the chapter
‘Socket
panels’
on page 45 in the printed
Guide.
V.TAPE connection
Disconnect all involved systems from the
mains before you connect external
equipment. Use the 21-pin AV cable to
connect the video tape recorder to the
television.
> Connect the cable to the AV socket on the rear
of BeoCord V 8000.
> Then run the cable to the V.TAPE socket on the
back of the television.
If the connection between the television and
BeoCord V 8000 is lost or not connected
appropriately, then CONNECTION LOST appears on
the screen when you try to program a timed
recording. Restore the connection and try again.
Aerial connection
Use your external aerial connection (or cable
TV network connection) and the aerial cable
supplied with the video tape recorder.
> Connect the cable from your external aerial to
the signal input socket marked
on the rear
panel of BeoCord V 8000.
> Direct the aerial signal to the television, using
the aerial cable supplied with BeoCord V 8000.
> Plug one end into the socket marked TV on the
V 8000 and the other end into the aerial socket
marked TV on the television’s socket panel.
BeoVision 6
BeoCord V 8000
V.TAPE connection
Aerial connection
Summary of Contents for BeoVision 6
