Quick Setup Guide
It is typically simplest to edit one of the
factory default Presets when doing a
first-time setup.
Enter the edit mode by pressing the
“...” icon on the top right of the screen
and select the Preset you wish to
modify, or press the “+” icon to create
a new preset.
Enter the Beam Control menu
•
Select the desired Beam Width
(and Beam Direction, if
applicable)
•
Assign the appropriate Speaker
Role (Left / Right) to the Master
loudspeaker
•
Set the Distances from each
loudspeaker to listening position
•
Set the Speaker Levels at
listening position
Once this is complete, it is advised to
create an Active Room Compensation
(ARC) filter. To start this process,
connect the microphone to the panel
on the back of the Master loudspeaker
and enter the ARC menu.
•
Enter the edit mode by pressing
the “...” icon on the top right of
the screen
•
Press the “+” icon to create a
new ARC filter
•
Follow the instructions for
microphone placement and
perform the three
measurements.
•
Once the measurement
procedure is complete, select the
ARC filter you have made to
apply it to the listening Preset.
Enter the “Advanced” menu
•
Verify that the Latency Mode is
set to “Auto”
•
If your source is a Bang &
Olufsen television, take note of
the Preset Number in this menu
Rename the Preset if desired.
The loudspeakers are now optimised
for a third-party source and ready for
use.
If the BeoLab 90’s are connected to a
BeoVision television:
•
Create a Speaker Group in the
television
•
Include the BeoLab 90’s in the
“Speaker Connections” menu
•
Assign the appropriate Speaker
Roles to the loudspeakers
•
Set the Distances from each
loudspeaker to listening position
•
Set the Speaker Levels at
listening position
•
Assign the Speaker Preset in the
BeoVision menu to match the
appropriate Preset number in the
BeoLab 90’s
13