background image

 

EHT-2/4/5/6 and 8 

In Wall / Ceiling models

Congratulations on investing in JENSEN’s Architectural Speaker 

Systems. You will find this information valuable for the long-term 

enjoyment of your speaker system.

Break In Period.

 

Certain parts and materials are used in these EHT-2/4/5/6/8 products so 

maximum performance can be obtained in damp and dusty environments such as wall and ceiling 
cavities. Therefore, we strongly advise that you resist temptation to play your JENSEN speakers to 
their full capabilities until they have been properly broken in. This process should last appx. 20-40 
hours of music playback. This can easily be done by putting your compact disc player on Repeat 
mode, while playing a CD with reasonable Bass content at average room volume listening levels.

Installation.  

Step 1.

Decide the placement for your speakers. Advance planning in regards to the placement of 

your speakers is critical. It is imperative that the wall or ceiling cavity be free from debris, 
moisture, insulation, and any materials that are easily combustible. The mounting location must 
also be void of wall studs or bracing in the location for the cutout. Adequate depth for the speakers 
to fit flush to the wall or ceiling surface is important. If you are unsure of the contents of the wall 
in which you wish to mount the speakers, simply drill a small hole and using a metal coat hangar, 
insert the end of the hangar into the wall and twist it to feel for any debris or wall studs. Electronic 
Stud Finders work well also.

Step 2.

Once you have determined the final mounting position, use the supplied template and 

mark the cutout on the wall or ceiling, depending on the model purchased. To mark the cutout size, 
simply trace an outline of the supplied template, found in the box with a pencil.  

Step 3

.

Using the appropriate wall-cutting tool, accurately cut the hole in the wall material, based 

on the appropriate cutout dimension.   

Step 4.

 Install speaker cable(s) from the receiver or amplifier to the inside of the wall or ceiling, 

and leave enough slack in the wire so that it can hang out of the hole. 

Step 5.

Connect the speaker wire from the positive (RED+) terminal on the receiver to the 

positive (RED+) terminal on the speaker. Connect the negative (BLACK-) the same way to the 
negatives. Note: If you inadvertently reverse one of the connections (i.e. RED to BLACK) you will 
notice a severe lack of Bass from your system. This is called wiring your system “Out of Phase”. If 
this occurs, check the wiring and reconnect as necessary.  

Step 6.

 Remove metal grilles. (see below) For all models, gently adjust eyeball tweeter to aim 

towards main listening area. See below for fine-tuning. For models EHT-2/6/8, set Boost switches 
to desired setting (see below). Insert the entire speaker into the hole, and using a Phillips 
screwdriver, tighten the screws attached to the dog clamps until firm. NIP THESE UP - DO NOT 
OVERTIGHTEN.  Note: If you are unable to install these speakers yourself, please contact an 
authorized electrician or installation contractor. 

Reviews: