Set up the loudspeaker
We recommend that you follow
this procedure:
– Disconnect your system from the
mains supply.
– Place the loudspeakers in your
setup.
– Set the switches to the correct
setting. This is explained in ‘Adapt
the loudspeakers to your setup’
(page 6).
– Connect your speaker system.
– Connect the entire system to the
mains again.
If you mount the loudspeaker on a
wall bracket, you cannot assemble
the base to the loudspeaker.
Cautions
– Make sure that the loudspeakers
are placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
stands and wall brackets only!
– The loudspeakers can only be
switched off completely by
disconnecting them from the
wall socket.
– The loudspeakers are designed
for indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– Remember that all speakers in a
setup must be connected to a
mains outlet, and that they are
designed to be connected to the
mains at all times, as this allows
them to switch on automatically.
– Do not attempt to open the loud
speaker. Leave such operations
to qualified service personnel!
Column and base
It is easiest to assemble the base and
the speaker column if the loud
speaker is placed on the two foam
packaging blocks – as shown.
Remove the small plastic cylinder
from the threaded end of the loud
speaker, and push the base onto
the threaded end. Fasten the base
to the column with the washer and
nut. Tighten the nut carefully.
4
NOTE! The type number of the
loud speaker appears on the label
which is placed on the inside of the
socket panel cover.
