6
To connect the loudspeaker to
your system, you will require a
mains cord and a Power Link
cable. These cables are available
as optional accessories from your
Bang & Olufsen retailer.
Use a Power Link cable of the
correct type to connect the
loudspeaker to a Power Link
socket on the Bang & Olufsen
system.
For further information about
connections, refer to the Guide
enclosed with the system.
POSITION switch
This switch has two settings:
F
(Free-standing position) and
W
(Wall position).
Which setting to use is explained in
‘Adapt the loudspeaker to your
room’
(pp. 8–9).
POWER LINK socket
Use this socket to connect the
loudspeaker to one of the Power
Link sockets on the Bang & Olufsen
system – see the next page.
Mains connection
The socket marked
~
is for mains
supply input (connection from the
wall outlet).
Note: The mains cord from the wall
outlet must be fastened to the cable
clamp on the loudspeaker – as shown
on the next page.
Cable connections
The socket panel is located on the rear of the loudspeaker.
POSITION switch
Cable clamp
POWER LINK
socket
For future use
UG02 BeoLab 7-1 (non-BV7)_ENG.indd 6
UG02 BeoLab 7-1 (non-BV7)_ENG.indd 6
9/30/04 11:24:28 AM
9/30/04 11:24:28 AM
