Fault flow chart 3.1
1
2
3
4
5
1 = Data -
2 = 5V
3 = Charge ID
4 = Data +
5 = GND
* Pin explanation for Charger
30
1
P3
1
6
1
3
* PCB Keypad
Fault flow chart
No
Yes
Confirm the battery
is fully charged
(2.4V VBAT on
Keypad*, P2 pin 1)
OK?
Place Beo5 in
charger. Confirm
that ‘Charging’
appears on the
Display
OK?
Remove Beo5 from
charger and confirm
by measuring, 5V at
Charger*
OK?
Replace Adaptor
OK?
Replace Charger
Wait for Beo5 to
recharge battery
OK?
Disconnect battery.
Place Beo5 in
charger. Confirm
that Display turns on
OK?
Replace Keypad OK?
Replace Display
Replace battery
Press OK key for at
least 2 sec. and
confirm Beo5
illuminate the
Display
OK
Replace Display
Place Beo5 in
Charger. Confirm
that ‘Charging’
appears on the
Display
OK?
Replace Keypad OK?
Replace Display
Fault symptom:
No operation
No back light
No key illumination
Possible causes:
Defective battery
Defective Charger -> low battery
Defective keypad
Defective Display
Summary of Contents for Beo5
