B&R Panel PC 3100, User Manual

Page: 69 / 277

Technical data
Automation PC 3100 User's manual V 1.00
Translation of the original documentation
69
2.3.5 Interface options
Information:
It is important to note that not every interface option can be connected in interface slots 1 and 2. For
more information, see sections "IF option 1 slot" on page 46 and "IF option 2 slot" on page 47 .
Information:
For information about replacing or installing an interface option, see section "Installing the interface
option and DDR4 SDRAM" on page 254 .
Depending on the IF option used, it may be necessary to load the default settings in BIOS after replace-
ment or installation ( see "Exit" on page 175 ).
2.3.5.1 5AC901.I232-00
2.3.5.1.1 General information
Interface option 5AC901.I232-00 is equipped with an RS232 interface.
•
1x RS232 interface
•
Compatible with APC910/PPC900 and APC3100/PPC3100
2.3.5.1.2 Order data
Model number Short description Figure
Interface options
5AC901.I232-00 Interface card - 1x RS232 interface - For APC910/PPC900/
APC3100/PPC3100
Table 63: 5AC901.I232-00 - Order data
2.3.5.1.3 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for this accessory
and may differ from those of the complete system. The data specified for the complete system applies
to the complete system in which this accessory is installed, for example.
Model number 5AC901.I232-00
General information
B&R ID code 0xF400
Interfaces
COM
Type RS232, modem supported, not galvanically isolated
Design DSUB, 9-pin, male
UART 16550-compatible, 16 byte FIFO
Max. baud rate 115 kbit/s
Electrical characteristics
Power consumption 1 W
Operating conditions
Pollution degree per EN 61131-2 Pollution degree 2
Environmental conditions
Temperature
Operation 0 to 60°C
1)
Storage -20 to 60°C
Transport -20 to 60°C
Table 64: 5AC901.I232-00 - Technical data
StockCheck.com