B&R Automation PC 620, User Manual

Page: 311 / 594

Software • BIOS options
Section 4
Soft
w
are
311 Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
1.8 Exit
Figure 145: X945 Exit Menu
BIOS setting Meaning Setting options Effect
Save Changes and
Exit BIOS setup is closed with this item.
Changes made are saved in CMOS after
confirmation, and the system is rebooted. OK / Cancel
Discard Changes
and Exit With this item you can close BIOS setup
without saving the changes made. The
system is then rebooted. OK / Cancel
Discard Changes In the event that settings were made
which the user can no longer remember,
changes can be reset as long as they
haven't been saved. OK / Cancel
Load CMOS
Defaults This item loads the CMOS default values,
which are defined by the DIP switch
settings. These settings are loaded for all
BIOS configurations. OK / Cancel
Table 195: X945 Exit Menu setting options
Main Advanced Boot Security Power Exit
Exit Options Exit system setup
after saving the
changes.
Discard Changes and Exit
Discard Changes
F10 key can be used
for this operation.
Load CMOS Defaults
Select Screen
Select Item
Enter Go to Sub Screen
F1
General Help
F10 Save and Exit
ESC Exit
Save Changes and Exit
BIOS SETUP UTILIT Y
v02.66 (C)Copyright 1985-2009, American Megatrends, Inc.