9
During setup of a source via the SOURCE
LIST SETUP menu, you can select how a
Peripheral Unit Controller (PUC) product,
such as a set-top box (STB), is connected.
You must select which socket the PUC
cable is connected to (1A, 1B, 2A or 2B).
Then you choose between PLUG (cable)
and IR BLASTER. If you select PLUG, you
must choose between MODULATION ON
and MODULATION OFF. For information
about type of cable and modulation
settings, contact your retailer.
IR-transmitters:
To operate non-Bang &
Olufsen products with a Beo4/Beo6 remote
control, attach a Bang & Olufsen IR-
transmitter on your non-Bang & Olufsen
product and then connect it to the
corresponding socket marked PUC on the
connection panel. Attach the transmitter
near the IR-receiver on the connected
equipment to ensure remote control
operation. Before attaching it, check that
you can operate the equipment menus on
the television screen using the Beo4/Beo6
remote control.
For an extra PUC cable, contact your retailer.
For information about download of PUC
tables for set-top boxes,
and
If you want to watch coded channels,
contact your service provider. The
service provider will register you as an
authorised viewer, usually requiring
payment. You will then be provided
with a Smart Card and a CA Module.
Note that these will only be valid for
one service provider and therefore only
works with certain channels.
The CA module is a ‘card reader’ for your
Smart Card which decodes the coded
signals sent out by the service provider.
Only uncoded digital channels, also
known as ‘free-to-air’ channels, are
available without Smart Cards and CA
Modules.
Smart Cards and CA Modules may also
give access to special menus which are
not described here. If this is the case,
follow the instructions from your service
provider.
Contact your retailer for information about
compatible CA Modules.
The Smart Cards must remain in the CA
Modules, unless your service provider asks
you to remove them. This is important in
case your service provider wishes to send
new information to your Smart Card.
Insert a Smart Card carefully into a CA
Module.
The CA Module has one protruding edge on
one side and two protruding edges on the
other side. If the television does not receive
any signal, check that the Smart Card and
CA Modules are inserted correctly.
Digital channels
Control
>> Connections
STB
STB
PLUG
IR
COMMON INTERFACE
CHIPSIDE
CHIPSIDE
Continues …
