Bandini Industrie GiBiDi GROUND 610, Instructions For Installations

Page: 19 / 72

UK
19 GROUND
- Embed the operator box in the foundation hole.
OPERATOR INSTALLATION
N.B.
Check that the cement in the foundation hole has dried sufficiently before installing the operator.
1- Fit the lever unit to the box pin
(10)
.
2- Procure a U-bracket of the dimensions indicated in
(11)
and close it on the pillar side using a plate as shown in
(12/a)
and
(12/b)
.
3- Weld the U-bracket or the gate on the operator support arm
(13)
.
4- Position the gate in the guide bracket and hinge it in the upper part.
5- Check manually that the gate is free to open and close coming to a complete halt on the mechanical end-stops.
The leaf must move smoothly and uniformly without irregular friction.
1- Open and close the gate leaf determining the desired opening and closing by means of the mechanical limit
switches
A(14)
.
2- Once the limit switches have been adjusted, move the leaf into the gate-open position.
3- Fasten the operator checking that it is exactly positioned
(14)
.
4- If using the limit switches, refer to the next paragraph.
5- Fit the connecting rod (left or right) as shown
(15)
.
6- At this stage, it is advisable to grease the operator output shaft and the lever fastening pins.
7- Power the operator and move the leaf into the gate-closed position.
8- Proceed with installation of the second operator (where applicable) repeating the above described procedures.
9- Fit the cover on the operator using the screws provided
(16)
.
FITTING THE GATE
OPTIONAL LIMIT SWITCH (17-18)
The kit is made up of:
a) Limit switch disc
b) Limit switch
c) Sensor board cable 4x0.5 mm²: blue= close, purple= open, red= positive, brown= negative
d) Magnets
e) 4 m long cable
f ) Retaining screws
1- Fit the two cheese-headed screws
e(18)
directly on the operator body.
2- Fasten the sensor board
c(18)
using the two screws
f(18)
above the two screws
e(18)
, and run the output cable
through the grooves on the operator.
3- Secure the limit switch disc on the output lever using the screws M3 x 6 mm
(20)
.
4- Fasten the assembly formed by the disc and the lever on the operator output shaft using the pin
(20)
.
5- Fasten the connecting rod between the output levers using the relative pins and seeger
(15)
.
6- POWER THE OPERATOR
7- Taking the sensor as reference, assemble the two limit switches
b(19)
on the disc
a(19)
using the screws and nuts
c(19)
and fasten one in the gate-open position and the other one in the gate-closed position and run a full cycle.
LIMIT SWITCH FITTING AND ADJUSTMENT