B&G Zeus3S, Installation Manual, Page: 39 / 51

Serial output
Selection determines whether the data is output via Tx lines, and will enable editing of the
output sentences list.
Serial output sentences
This list allows control over which sentences that are transmitted to other devices from the
NMEA 0183 port. Due to the limited bandwidth of NMEA 0183 it is desirable to only enable
the data that is required. The less sentences that are selected, the higher the output rate of
the enabled sentences.
Ethernet/WiFi
The NMEA 0183 data stream is output and made available to tablet devices and PCs, via WiFi
or Ethernet connection. The dialogue provides IP and port data typically required for
configuring the application on the third party device.
Ú
Note:
Other MFDs cannot decode this information back to NMEA 0183, to use the data
as a source. To share data a physical NMEA 2000 or NMEA 0183 connection is still
required.
System setup | Zeus³S Installation Manual
39