optional devices
h1000 pilot
Page 46
acp joystick
description
The joystick allows direct control of the rudder via the autopilot control electronics. The unit is deck-
mountable, allowing it to be used both above and below decks. A 10m (30ft) 3-core screened cable is
used to connect the unit directly into the
h1000 ACP
unit.
Joystick steering is engaged and disengaged with the separate red button, which should be mounted in
the same manner as the MOB button, at a location close to the position selected for mounting the
joysick. The lever can only be moved to port or to starboard.
siting the joystick unit
•
At a convenient position within easy reach of the helmsman.
mounting procedure
•
To ensure correct steering sense the unit is marked with two indents. The unit must be installed
with these forward.
•
The unit requires at least 65mm (2.5") clearance behind the selected mounting position.
•
Use a 40mm (1 9/16") hole cutter for the joystick body.
•
Ensure the gasket is fitted under the joystick body flange.
•
Secure in place with the self-tapping screws supplied.
•
Route the cable to the ACP unit. Connect as per instruction detailed in the relevant section of this
manual.
Refer to Page 34 of this manual for the wiring diagram details for this equipment.
Summary of Contents for HB-1000I
