
h1000 pilot
description/installation
Page 11
rudder reference unit
The rudder hardover angle should only be limited by the rudder stops, not the rru linkage or pilot drive
unit. Check that when hardover, the rru arm and drag-link do not form a straight line. If this occurs the
steering system could become damaged or jammed endangering the boat and crew.
This fault can easily be rectified, by adjusting the position of the RRU.
linear feedback unit
Where installation of the conventional rudder reference unit is difficult or physically impossible, a
linear feedback unit can be used. The linear feedback unit comprises of a tube approximately 23mm
(7/8 inch) in diameter and 324mm (12¾ inch) long. This assembly is clamped to the side of the linear
actuator using a special bracket kit. The linear feedback shaft is attached to the tiller bracket using
the pin supplied with all blue rams.
Note:
This unit requires careful installation and alignment, which should be carried out by your
dealer or supplier. For electrical connection, refer to the wiring diagram detailed on
Page 35 of this manual.
Summary of Contents for HB-1000I
