![background image](http://html1.mh-extra.com/html/bandelin/sonorex-technik-rl-70-2-uh/sonorex-technik-rl-70-2-uh_operating-instructions-manual_3826107011.webp)
23906-000 en/2022-11
11 / 30
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
2 Preparation
Carefully unpack the ultrasonic bath and accessories and inspect them for
completeness or possible transportation damages. Any identi
fi
ed damage or defects
must be communicated immediately and in writing to the transportation company and
to the supplier.
Before operation, the ultrasonic bath should be allowed to stand for 2 hours at its
operating location so that it can adjust to the ambient conditions.
2.1
Scope of delivery
1 Ultrasonic bath, see delivery slip
1 Accessories kit
1 Operating instructions
Additional accessories as ordered – see delivery note
2.2
Setup / assembly
• Place the ultrasonic bath atop a
fi
rm, level and dry surface. In doing so,
- observe the maximum weight of the tank, including liquids.
For net weight, see the technical data in chapter 1.4.
- do not block the air supply below the tank.
- guard against moisture and wetness – risk of electric shock.
Set-up
Fully remove transportation aids (pallets, transport safety devices).
Set up the ultrasonic bath in a dry room.
Install the ball valve, hose socket and hose that are included in the delivery,
pursuant to the enclosed installation instructions.
2.3
Putting into service
Thoroughly rinse the ultrasonic bath's oscillating tank with water before its
fi
rst use.
Verify that the control buttons are in the "o
ff
" position, i.e. the switch indicators point
upwards, then connect the bath to the mains.
Conduct a function test on the ultrasonic bath – brie
fl
y plug in the ultrasound
(maximum of 1 to 2 seconds), a hissing noise should be heard. Set to "0" once again.
Hang accessories in the ultrasonic bath and place lid on top.
Connect peripheral devices if required – see additional documentation.