![background image](http://html.mh-extra.com/html/bandd/hss-bdah-01/hss-bdah-01_installation-manual_460053009.webp)
9
Scranton, IA 51462
Phone (712) 652-3424
www.bdmfginc.com
ELECTRIC HEAT STRIP INSTALLATION PROCEDURE
WARNING:
Only use electric heat strip components provided by B&D Mfg., Inc. The electric heat strip components
were specially designed for the HSS® Air Handler. Any use of different components may not be a compatible fit
and may cause harm to the unit and will void all warranty.
AVERTISSEMENT: N'utilisez que des composants de bande chauffante électrique fournis par B&D Mfg., Inc.
Les composants de la bande chauffante électrique sont spécialement conçus pour le système de traitement d'air
HSS®. Toute utilisation de différents composants peut ne pas être compatible et causer des dommages à
l'appareil et annulera (toute) la garantie.
1. Disconnect power and lock out.
2. Remove bolt (8.1) from the front access panel (1)
3. Remove bolt (8.2) from the blower access panel (2)
4. Remove both access panels (1 & 2) by lifting up, then out and down.
5. Remove both inner plenum covers (4a & 4b), 4 bolts each (8.3 & 8.4).
6. Remove the 4 heat strip assembly cover screws (8.5) and heat strip assembly cover (6)
7. Press in the 4 heat strip coil frame end caps (7) into the heat strip frame support (9).
8. Slide heat strip assembly (5) through the heat strip access hole using the side access hole for assistance in lining up the
heat strip frame ends, into the 4 coil frame end caps (7)
9. Bolt heat strip assembly (5) to the internal plenum (3) using the 4 bolts (8.3) from inner plenum cover (4a).
10. Bolt the inner plenum front cover (4b) onto the inner plenum using the 4 cover screws (8.4).
11. Plug in the 24V, 4 position control plug (10) to control box 4 position plug receptacle (11).
12. A separate 208V/240V power source is needed to supply power to the heat strip from a/# power source
13. After the heat strip is powered replace the heat strip assembly cover (6) with the 4 screws (8.5).
14. Replace both access panels (1 & 2) with bolts (8.1 & 8.2).
NOTE: Inner plenum cover (4a) is no longer needed
8.5
6
10
5
7
8.3
4a
8.4
4b
3 9
11
2
1
FRONT ACCESS PANEL
BLOWER ACCESS PANEL
8.1
8.2
HEAT STRIP ACCESS HOLE
SIDE ACCESS HOLE