11
114A2991
INSTALL THE SAFETY INFRARED REVERSING
SENSOR (See Accessories)
Install this accessory for all installations on doors over 2.5m
in height and when the closing force as measured on the
bottom of the door is over 400N (40kg).
After opener has been installed and adjusted,
The Safety
Infrared Reversing Sensor
accessory can be installed.
Instructions are included with this accessory.
The Safety Infrared Reversing Sensor provides an additional
measure of safety against a small child being caught under a
garage door.
It uses an invisible
beam which, when
broken by an
obstruction, causes
a closing door to
open and prevents
an open door from
closing and is
strongly recommended for homeowners with young children.
Note:
The opener will automatically detect the Safety Infrared
Reversing Sensor when it is installed. The opener will not close
unless the sensors are aligned and functioning.
PROGRAM YOUR OPENER AND REMOTE
Activate the opener only when door is in full view, free of
obstruction and properly adjusted. No one should enter or
leave garage while door is in motion. Do not allow children to
operate push button(s) or remote(s). Do not allow children to
play near the door.
Your garage door opener receiver and remote control transmitter
are set to a matching code. If you purchase additional remote
controls, the garage door opener must be programmed to accept
the new remote code.
Program the Receiver to Match Additional Remote Control
Codes:
Using the orange “LEARN” Button:
1. Press and release the orange “learn” button on the opener.
The learn indicator light will glow steadily for 30 seconds (1).
2. Within 30 seconds, press and hold the button on the hand-held
remote that you wish to operate your garage door (2).
3. Release the button when the opener light blinks. It has learned
the code. If the light bulb is not installed, two clicks will be
heard (3).
Using the Multi-Function Door Control:
1. Press and hold the button on the hand-held remote that you
wish to operate your garage door (4).
2. While holding the remote button, press and hold the LIGHT
button on the Multi-Function Door Control (5).
3. Continue holding both buttons while you press the push bar on
the Multi-Function Door Control (all three buttons are held) (6).
4. Release buttons when the opener light blinks. It has learned the
code. If the light bulb is not installed, two clicks will be heard (7).
Now the opener will operate when the remote control push button
is pressed. If you release the remote control push button before
the opener light flashes, the opener has not learned the code.
To Erase all Remote Control Codes:
To deactivate any unwanted remote, first erase all codes: Press
and hold the orange “learn” button on opener until the learn
indicator light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless entry
you wish to use.
3-Channel Remote:
The large button is factory programmed to operate your opener.
Additional buttons on any 3-channel remote or mini-remote can be
programmed to operate this or other B&D garage door openers.
1
3
2
7
6
LOCK
LIGHT
5
LOCK
LIGHT
4
1
3
2
60 s
120 s
180 s
O
–