B&D Doors is a division of B&D Australia Pty Ltd P:
13 62 63
W: www.bnd.com.au
3
Smart Phone Control Kit Manual
Sectional Door Opener Set Up
SDO-2V2 Advance & SDO-3 S and Panel Pro
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Remove the cover or back cover via screw at top.
c. Remove the grommet out of the chassis.
d. Cut (1) one side of the grommet with a knife or scissors.
e. Slide the network timing harness
7
into the cut in the grommet.
f. Refit grommet to chassis by sliding the harness through hole
before fitting grommet.
g. Connect the harness to the network / programmer pin on the
control board.
h. Refit the cover.
Mount and connect Transceiver
a. Plug the other end of the harness into the transceiver
6
.
b. Using the velcro
9
stick the transceiver
6
on the top of the
opener as shown.
WARNING:
DO NOT drill into the chassis or covers. No
screws are required to secure the transceiver.
Re-setup and Test the Opener
a. Reconnect power and remove the button cover.
b. Setting Limits:
i. If limits have not been set, follow the openers installation sheet
to set limits.
ii. If limits were set previously, clear limits and follow openers
installation sheet to set limits.
c. Refer to the Smart Phone Control Kit User Guide to set up network
capabilities.
Network Pin
Grommet
Back cover screw
Network /
Programmer Pin
6
6
7
Grommet
PanelPro
Grommet
Network /
Programmer Pin
