UL4000-D
ULTRA-LOK® TOOL
BAND-IT IDEX, Inc.
Document # P09986 Rev. B
A Unit of IDEX Corporation
© Copyright
4799 Dahlia Street
www.BAND-IT-IDEX.com
BAND-IT IDEX, Inc. 2016
Denver, CO 80216-0307 USA
All Rights Reserved
P: 1-800-525-0758
F: 1-800-624-3925
4
Setup Instructions
1.
Read safety instructions and operator’s manual for the Metabo BS 18 LTX cordless Drill. Check to make sure
drill is properly set up for use with Band-It Ultra-Lok
tool as follows:
a. Drill spindle has a Clutch Assembly (Band-It # UL4001)
b. See page 6 for recommended Drill speed and torque settings.
2.
Charge Drill Battery according to the operator’s manual.
3. To mount the Drill onto the Band-It Ultra-Lok
Tool:
a. First, using the two #10-32 x 3/8" screws (M06187), tighten the Tool Body Adapter (M07697) on the
Tension Tool (UL0001) with 20
–30 in-lbs.
b. Place the Adapter Collar (M08288) over the Tool Body Adapter.
c. Orient the Drill Clutch Pin (M07187) horizontally (see page, 5 Figure 2).
d.
Carefully place the Tool Body Adapter over the Drill’s collar. If there is any additional resistance, gently
rotate the Tension Tool until the Tension Screw engages with the Drill Clutch (M04298) (see page 5,
Figure 3), and rotate Tension Tool to the desired orientation.
e. Position Tool Body Adapter to butt-up against the shoulder of the drill.
f.
Slide the Adapter Collar against this shoulder and fasten to 40
–60 in-lbs.
4. This tool was designed for, and can only be used with BAND-IT 1/2" and 3/4" wide Ultra-Lok
clamps. Do not
attempt to use on any other type of clamp style. Only use 1/2" wide clamps when the optional 1/2" Shear Plate
(BAND-IT # M09387) has been installed in the head in place of the 3/4" Shear Plate. See page 15 f
or ½” blade
change procedure.
Figure 1