IT5000-C / IT6000-C
3/8” IT Tool
www.BAND-IT-IDEX.com
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 18 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
•
The dimple clip is designed to eliminate the occurrence of undetectable loose ties.
This provides a positive visual indicator to identify good vs. bad tie installation.
•
Installing the clip
–
Step 1:
Locate clip on front of tool head
–
Step 2:
Install M4x5 screw to hold clip in place. Do not exceed 6 newton meters
(N-m) torque. [ 53 inch pounds (in-lb) ] Over tightening will cause the screw thread
to strip.
•
Tool orientation is critical to proper function. The tool must be aligned so the clip is
contacting the work piece while the clamp is being tensioned in order to make sure
the buckle locates inside clip during assembly.
•
If the blade is not contacting the work piece during clamp tensioning, the clip will
overshoot the buckle. When the buckle slides under the clip, the dimple lock
cannot form and the tie will be loose. There will also be a sharp edge after cutoff.
Dimple Clip Guide (IT6000 only)
C
O
R
R
E
C
T
IN
C
O
R
R
E
C
T
