Section 8: Repairs
Bambi MAX Service Manual
– Models HL4000-HL9800 45
3.
Remove the top ring and pass the coiled control cable
through the middle of the ring. Take the ring and old
seal out of the shell.
4.
Place the ring on a level surface with all bolts inserted
into the ring. Slip the new seal over the bolts.
5.
Pass the control cable through the ring, making sure
to pass the cable through from the seal side.
6.
Return the ring with seal to the shell.
7.
Start all bolts into the tube, turning them in about
1/8". This allows you to locate the holes in the tube
easier by lifting the ring and seal to see the holes.
8.
Tighten all bolts equally as they are going into plastic.
Do not over tighten as you would in metal.
9.
String the control line and, before unrolling the coil
of cable, pass it through the center of the IDS hub.
Once all the cable is outside the bucket with no slack,
push it 6" back into the bucket. Now, using tie-wraps,
attach the cable to the deployment cable eye on the
hub. Use at least two tie-wraps.
