baltur TBG 2000 LX ME, Instruction Manual For Installation, Use And Maintenance

Page: 56 / 68

MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
IMPORTANT
Before performing any operation on the burner disconnect the
main panel from the power supply.
• Clean air dampers, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace it, if necessary.
• Then check that it is correctly positioned according to the electro -
de disc adjustment diagram.
• Have the burner and the chimney cleaned by specialised person -
nel (stove repairer); a clean burner is more efficient, lasts longer
and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from impurities
or deposits deriving from the installation environment and/or from
combustion.
• Analyse combustion gases and check emissions values.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• Unscrew the anchoring screws (11) and open the ventilating body.
• Pull out the ignition cable (14) from the gas pilot electrode termi -
nal.
• Unscrew the nut (1) connecting the pilot pipe to the bushing of the
corresponding gas train.
• Unscrew the nut (2) and screw (3) connecting the gas fitting (4).
• Pull out the entire mixer unit (5) in the direction shown by the
arrow.
• Complete the maintenance and cleaning operations and reas -
semble the entire mixing unit, following the operations described
above in reverse order.
IMPORTANT
Before closing the burner, connect the ignition cable to the
electrode terminal and secure it to the gas delivery connection
with a tie.
14
0002951260N4
11
3
2
4
1
0002951260N5
5
0002951260N6
GAS THROTTLE VALVE POSITION INDEX
0002939690
22 / 32
0006160502_202306
ENGLISH