baltur BTL 14, Installation, Use And Maintenance Instruction Manual

Page: 55 / 60

ENGLISH
25 / 28
0006080871_201711
TROUBLESHOOTING INSTRUCTIONS
ANOMALY
The burner locks out with the flame on (red
lamp on). The fault is in the flame control
device.
The burner goes into lock-out spraying liquid
fuel but the flame does not ignite (red light
on).
The burner goes into lock-out without
spraying fuel.
The burner does not start up.(The equipment
does not perform the start up program).
POSSIBLE CAUSE
1 Photoresistance severed or fouled
with smoke.
2 Insufficient draught.
3 Flame detector circuit interrupted in
the equipment.
4 Dirty deflector disk and diffuser.
1 Ignition circuit severed.
2 The ignition transformer cables are
discharging to ground.
3 The ignition transformer cables are
not well connected.
4 Ignition transformer is faulty.
5 The electrode faces are not at the
right distance.
6 Electrodes discharge to earth
because they are dirty or their
insulation is cracked: check also
the porcelain insulator terminals.
1 Pump pressure is not regular.
2 Water in the fuel.
3 Too much combustion air.
4 Air passage between deflector disk
and diffuser excessively closed.
5 Nozzle worn out or dirty.
1 Thermostats (boiler or room) or
pressure switches are open.
2 Photoresistant-cell in short circuit.
3 Absence of line voltage, main
switch open, meter switch tripped
or absence of line voltage.
4 Thermostat line not wired according
to diagram or open thermostats.
5 Equipment internal fault.
REMEDY
1 Clean or replace.
2 Check all the smoke ducts in the
boiler and in the chimney.
3 Replace the equipment.
4 Clean.
1 Check the entire circuit.
2 Replace.
3 Restore the connection.
4 Replace.
5 Return to the required position.
6 Clean and if necessary replace
them.
1 Adjust.
2 Drain water from the tank using
a suitable pump. Never use the
burner pump for this purpose.
3 Reduce combustion air.
4 Correct the position of the
combustion head adjusting device.
5 Clean or replace.
1 Raise the thermostats settings,
or wait that the contacts close for
natural decrease of temperature or
pressure.
2 Replace it.
3 Activate switches or wait for power
to return.
4 Check the connections and
thermostats.
5 Replace it.