baltur BTL 0, Instruction Manual

Page: 37 / 64

• If the burner repeatedly shuts down in lock-out, do not keep
trying to manually reset it but call a qualified technician to solve
the unexpected problem.
• If you decide not to use the burner for a while, close the valve or
valves that supply the fuel.
Special instructions for using gas.
• Check that the feed line and the train comply with current
standards and regulations.
• Check that all the gas connections are properly sealed.
• Do not leave the equipment on when it is not in use and always
close the gas cock.
• If the user is away for some time, close the main gas feed valve
to the burner.
• If you smell gas:
- do not operate electrical switches, the phone or any other
object that can cause sparks;
- immediately open doors and windows to create a draught to
clear the air in the room;
- close the gas cocks;
- have professionally qualified personnel correct the fault.
• Do not block ventilation openings in the room where there is gas
equipment or dangerous situations may arise with the build up
of toxic and explosive mixtures.
FUEL SAFETY INSTRUCTIONS
• If the user is away for some time, close the main gas feed valve
to the burner.
• If you smell gas:
- do not operate electrical switches, the phone or any other
object that can cause sparks;
- immediately open doors and windows to create a draught to
clear the air in the room;
• close the gas cocks
• have professionally qualified personnel correct the fault.
INSTRUCTIONS ON ELECTRICAL SAFETY
• Check that the equipment is properly grounded according to the
safety standards in force.
• Do not use the gas pipes to ground electrical equipment.
• If in doubt, call for a careful electrical check by a qualified
technician, since the manufacturer will not be liable for any
damage caused by a poor ground connection.
• A professional check should be carried out to ensure that
the electrical installation is adequate for the maximum output
absorbed by the system. This is indicated on the data plate.
• Make sure that the system cable cross-section is suitable for
the power absorbed by the equipment.
• The use of adaptors, multiple plugs and/or extension leads to
supply power from the mains to the appliance is not allowed.
• The mains supply connection requires an omnipolar switch
with a contact opening gap equal to or greater than 3 mm in
accordance with current safety regulations.
• Unsheathe the external insulating cover of the power cable to
the necessary extent for the connection, thus avoiding the wire
from coming into contact with metal parts.
• The electrical supply to the burner must have neutral to ground
connection. In the case of a ionisation current check with neutral
not to ground, it is essential to make a connection between
terminal 2 (neutral) and the ground for the RC circuit.
• If the user is away for some time, close the main gas feed valve
to the burner.
• The use of any components that use electricity means that
certain fundamental rules have to followed, including the
following:
- do not touch the equipment with parts of the body that are
wet or damp and/or with damp feet
- do not pull on electrical cables;
- do not leave the equipment exposed to atmospheric agents
(such as rain or sun etc.) unless there is express provision
for this.
- do not allow the equipment to be used by children or
inexperienced persons.
- The power supply cable for the equipment not must be
replaced by the user. If the cable is damaged, turn off
the equipment. To replace the cable, contact exclusively
qualified personnel.
- If you decide not to use the equipment for a while it is
advisable to switch off the electrical power supply to all
components in the system that use electricity (pumps,
burner, etc.).
ENGLISH
5 / 30
0006080748_201504