baltur BGN 450 ME, Installation, Use And Maintenance Instruction Manual

Page: 32 / 56

ENGLISH
4 / 26
0006160036_201504
SAFETY INSTRUCTIONS FOR INSTALLATION
• The equipment must be installed in a suitable area with adequate
ventilation according to the standards and regulations in force.
• The slots of the air extraction grilles and installation room
ventilation openings must not be obstructed even partially.
• In the installation site there must NOT be any risk of explosion
and/or fire.
• Thoroughly clean the inside of all pipes of the fuel supply
system before installation.
• Before connecting the burner check that the details on the plate
correspond to those of the utility supplies (electricity, gas, diesel
or other fuel).
• Make sure that the burner is firmly fastened to the heat generator
according to the manufacturer's instructions.
• Make the connections to the power sources properly as indicated
in the explanatory diagrams and following the standards and
regulations in force at the moment of installation.
• Check that the fume exhaust system is NOT obstructed.
• If you decide not to use the burner any more, the following
procedures must be performed by qualified technicians:
- Switch off the electrical supply by disconnecting the power
cable from the main switch.
- Cut off the fuel supply using the shut-off valve and remove
the control wheels from their position.
- Render harmless any potentially dangerous parts.
INSTRUCTIONS FOR START-UP, INSPECTION, USE AND
MAINTENANCE
• Start-up, inspection and maintenance of the equipment must
only be carried out by qualified technicians, in compliance with
current regulations.
• Once you have fastened the burner to the power generator,
make sure that during testing the flame produced does not
come out of any slots.
• Check for the seal of fuel supply pipes connected to the
equipment.
• Check that the fuel flow rate matches the power required by
the burner.
• Set the burner fuel capacity to the power required by the heat
generator.
• The fuel supply pressure must lie between the values indicated
on the data plate located on the burner and/or in the manual
• The fuel supply system is suitably sized for the flow required
by the thermal module and that it has all the safety and control
devices required by current standards.
• Before starting up the burner, and at least once a year, have
qualified technicians perform the following procedures:
- Set the burner fuel capacity to the power required by the
heat generator.
- Check the combustion adjusting the comburent and/or
fuel air flow to optimise the combustion performance and
emissions according to the regulations in force.
- Check the regulation and safety devices are working
properly.
- Check for the correct operation of the combustion products
exhaust duct.
- Check for the seal of fuel supply pipes in their internal and
external parts.
- At the end of the adjustment procedures, check that all
the mechanical locking devices of regulation systems are
properly tightened.
- Make sure that the burner use and maintenance manual are
available and within your reach.
RESIDUAL RISKS
• In spite of the accurate product planning according to the
regulations in force, residual risks may still be present during
correct use. They are indicated on the burner by means of
specific Pictograms.
CAUTION
Mechanical parts in motion.
CAUTION
Materials at high temperatures.
CAUTION
Energised electrical switchboard