7
Wall Mounting Instructions
Failure to follow these instructions will void your warranty and
could result in injury.
For Masonry Walls
Use the correct wall
predrill for your
Plastic Anchor
1.) Predrill the correct diameter predrill
in the wall with a masonry drill bit.
2.) Tap in the plastic anchor .
3.) Attach the unit to the wall with the .
correct length screw
Screw
Plastic
Anchor
For Wood Stud Walls
2”-3” Lag
Screw
Wood Stud
1/8”
Predrill
1.) Predrill a 1/8” hole in the through the
wall surface and into the wood stud.
2.) Attach the unit to the wall with a 2”-3”
Lag Screw.
For Sheetrock Walls
1.)
2.)
3.)
4.)
Drill a 1/2” diameter hole in the sheetrock.
1/2”
Hole
Snaptoggle
Anchor
Insert the Snaptoggle anchor into the 1/2” hole. Hold ends of straps together and pull toward you
until channel rests behind wall. Ratchet cap along straps until cap is flush with wall.
Push thumb side to side to snap off straps level with flange of cap.
Place unit over flange and insert bolt that came with the Snaptoggle and tighten bolt.
2-15-13
Bolt
Snaptoggle
Anchor in set
position
