6
7.)
Illustration # 6
P-10
P-15
P-17
A1
P-19
P-19
A3
P-9
P-10
Place a Bottom Cap (P-9) and a Washer (P-19) on the center joint of the Monitor Pole
Clamp (P-17) as you slide the Monitor Arm (P-15) into place as shown in illustration #6.
Place a Washer (P-19) on top of the Monitor Arm joint. Insert the long Screw (A1) down
through the Washer and in and out of the Monitor Arm and Moinitor Arm Clamp. Secure
the bolt in place using Nut (A3) and tighten. Snap in a Top Cap (P-10) on ther top and
bottom of the Monitor Arm. See illustration #6.
8.)
Follow the Wall Mounting Instructions on Page 7
for the correct wall anchors and screws to use on
your type wall.
Attach the Top Bracket (P-3) to your wall at the desire height you want your workstation to hang.
NOTE:
Have a second person hold the assembly from Step 7 up under the Top Bracket and against
the wall. Secure the Pole to the Top Bracket using one Screw (A2) as shown in illustration #7.
Tighten Screw (A2) using Allen Wrench (H1). Connect the Bottom Bracket (P-2), of the
assembly, to the wall using the same mounting method as you did on the Top Bracket.
90377_2-14-13
Illustration # 7
A2
P-2
P-3
P-13
P-11
P-11
8a.) Snap on three Caple Clips (P-11) and
two Arm Cable Clips (P-13) as shown
