10
Using The Triko
The Triko has 128 programs which remember the 8-channel premixer settings, the three Chorus settings ,
the Master settings and the optional card settings. An option in the System Menu (Mix = Prg / Glb) allows
controlling the premixer independent of the programs.
Programs loading
Press once the LOAD button.
Select a program using the SELECT encoder. The chosen program is displayed on the screen.
If the Auto Load (Ald = On /Off) system option is active, the program is automatically loaded. If not, press
one of the 3 encoders to load the program.
If the Mix Load (Mix = Prg / Glb) system option is active, the settings for Input section (premixer) included
in the program are loaded. If not, the settings of the premixer are not affected by the program.
The SELECT encoder allows to scroll through the 128 programs. The VALUE1 encoder allows direct access
to one of 16 archives. The number of the active archive is displayed on the top right corner of your screen,
for example: BNK=4.
Programs 1 to 8 of archive 1 can be called directly by pressing more than half a
second on one of 8 lit push buttons. These 8 slots would be best suited to store your
most important programs.
Programs editing
When you select a program, you might want to personalise it. All the parameters will be described in detail
further on in this guide in the chapter Sections. Each section has a dedicated lit button. Simply press the
corresponding button to get access to a section.
Inputs: Volume and balance controls for the 8 inputs.
Master: Volume and balance of the summation effects, volume and balance of non-modified signal
(DRY), rate and speed of the global over-modulation, destination source and dynamic modulation
rate.
Chorus 1: Volume and balance of Chorus 1, waveform and modulation speed, delay and modulation
rate.
Chorus 2: Volume and balance of Chorus 2, waveform and modulation speed, delay
and modulation rate.
Chorus 3: Volume and balance of Chorus 3, waveform and modulation speed, delay and modulation
rate.
Card: Volume and balance of the effects of the optional card, type of effect and filter, delay and
reinjection, waveform and modulation speed, modulation rate and specific parameter.
In each section, the SELECT encoder allows to select a couple of values, VALUE1 and VALUE2 encoders
allow to modify the corresponding parameter. The front panel design emphasizes the link between the
displayed value and its modification encoder.
It is not necessary to press on the encoders to change the values.