Balluff IO-Link BES M12MC1-YIC10F-S04G, User Manual

Page: 26 / 86

24 deutsch
8.6 Systembefehle (System commands)
Index
(dez)
Name Datenformat
(Länge)
Zugriff Werte bereich Beschreibung
0x0002
(2)
System
Command
UINT8 W 0x41 (65) = SP1SingleValueTeach Teach
Channel
Teachbefehl für SP1
0x42 (66) = SP2SingleValueTeach Teachbefehl für SP2
0x4B (75) = Decrease Setpoint Feinjustierung für kleineren Sr
0x4C (76) = Increase Setpoint Feinjustierung für größeren Sr
0x4F (79) = Teach Cancel Teach-Abbruch
0x80 (128) = Device Reset Reset Device Reset
0x82 (130) = Restore Factory
Settings
Sensorparametrierung auf
Werkseinstellung zurücksetzen
0xA5 (165) = Maintenance Reset Maintenancezähler auf 0
zurücksetzen
0xA6 (166) = Counter Reset Zählerstand zurücksetzen
Tab. 8-6: Systembefehle (System commands)
8.7 Fehlercodes (Error Codes)
Error Code Beschreibung
0x8011 Index not available
0x8012 SubIndex not available
0x8020 Service temporally not available
0x8023 Access denied
0x8030 Parameter value out of range
0x8031 Parameter value out of range – Above limit
0x8032 Parameter value out of range – Below limit
0x8033 Parameter length overrun
0x8034 Parameter length underrun
0x8035 Function not available
0x8036 Function temporally unavailable
0x8040 Invalid parameter set
0x8041 Inconsistent parameter set
0x8082 Application not ready
Tab. 8-7: Fehlercodes (Error Codes)
8.8 Ereignisse (Events)
Event Code Bedeutung Modus Typ Gerätestatus (device status)
0x4000 Temperature fault – Overload appears / disappears Error Failure
0x4210 Device temperature over-run appears / disappears Warning Out-of-Specification
0x4220 Device temperature under-run appears / disappears Warning Out-of-Specification
0x5100 General power supply fault appears / disappears Error Failure
0x5110 Primary supply voltage over-run appears / disappears Warning Out-of-Specification
0x5111 Primary supply voltage under-run appears / disappears Warning Out-of-Specification
0x7710 Short Circuit appears / disappears Warning Out-of-Specification
Tab. 8-8: Ereignisse (Events)
8
IO-Link-Schnittstelle: Parameter, Befehle und Ereignisse (Fortsetzung)
BES M12M_1-YIC_0_-S04G
Induktive Sensoren