Photoelectric Sensors
Laser Distance Sensor BOD 66M-L_04
No. 822 084 E
•
Edition 0911
7
Setting the switching distance
1. Install and align the sensor.
2. Position the object in the beam path.
3. Press the button for minimum 2 seconds or connect the
teach in wire for minimum 2 seconds to +U
B
. After
teaching over wire it must be connected back to
ground.
4. Remove the object. The yellow LED should go out. This
sets the switching distance.
Measuring accuracy
The sensor does not attain its full accuracy until operating
temperature is reached. This will take some time after
powering up. The warm-up time required depends on the
ambient conditions.
Technical Data
Optical
Working distance
200...2000 mm
Emitter light type
Laser-red light 660 nm
Laser protection class
2
Light spot diameter at 2 m
Divergent, 3x12 mm
Resolution
≤
5 mm
Gray value shift 90%/6%
≤
1 %
Repeatability for the same
target
≥
50x50 mm
2
± 0.5 %
Temperature drift
compensated
Electrical
Supply voltage U
B
18...30 V DC
No-load current I
0
max.
≤
150 mA
Rated operating current I
e
≤
250 mA
Analog output
−
BOD 66M-LA04
−
BOD 66M-LB04
1...10 V DC
4...20 mA
Switching output
PNP
Output function
Light-on
Voltage drop U
d
at I
e
≤
2 V DC
Rated isolation voltage U
i
250 V AC
Switchpoint setting
Teach In (button or wire)
Mechanical
Connection typ
connector
Housing material
GD-ZnAl
Lens material
Glass
Weight 420
g
Time
Ready delay
≤
300 ms
Switching frequency depending
on reflectivity of target
10…100 Hz
Turn-on delay
≤
100 ms
Turn-off delay
≤
100 ms
Displays
Supply voltage
Green LED
Output function
Yellow LED
Environmental
Enclosure rating (IEC 60529)
IP 65
Insulation class
II, double insulated
Reverse polarity protected
yes
Short circuit protected
yes
Permissible ambient light
≤
5000 Lux
Ambient temperature T
a
-20...+50
°C
