Balluff Network Interface EtherNet/IP™
www.balluff.com
6
3
First Steps
3.2. Mechanical
Connection
The module is secured by means of two M6 screws and two washers.
Insulation support is available separately.
3.3. Electrical
Connection
Power Supply
IN
7/8”, male
OUT
7/8” female
Pin
Function
Description
1
+24 V
Actuator supply
2
+24 V
Module / sensor supply
3
0 V
GND module / sensor and actuator supply
4
Note
Provide sensor/bus power and actuator power from separate power sources if
possible. The total current of the module must not exceed 9 A, even if the
module is looped through a circuit.
Grounding
Note
Der FE-connection between the housing and machine must display a low
impedance and is established via the clamping bolt.
Ethernet IP
Interface
M12, D-coded, female
Pin
Function
1
Tx+
Transmit Data +
2
Rx+
Receive Data +
3
Tx-
Transmit Data -
4
Rx-
Receive Data -